LCA chassis attachment point?
Thread Starter
Junior Member
Joined: Sep 2010
Posts: 47
Likes: 0
LCA chassis attachment point?
Has anybody had any expierence with the chassis mounting point deflecting under high loads? The sheetmetal seems thin around the LCA mounting poing on the chassis. I'm thinking about using some 3/16" plate and boxing in the whole area. I dont want the brackets moving when I launch the car off the transbrake.
Joined: Aug 2006
Posts: 12,804
Likes: 103
From: Central NJ
Car: 86 Trans Am
Engine: 408 stroker sbc
Transmission: TKO600
Axle/Gears: Moser full floater m9, 3:70 trutrac
Re: LCA chassis attachment point?
drag cars with a lot of traction and power tend to distort the metal in that location.
Thread
Thread Starter
Forum
Replies
Last Post
