Hi guys below are two videos where i go step by step on how to lower a thirdgen..
Some of the topics i cover are:
- How to index springs
- how to install lowering springs
- how to cut springs
- how to lower a v6 using v8 lowering eibach springs
- how to replace / install / change rear shocks and springs
....and more

Also please subscribe to my youtube channel (klowny1969] to be notified whenever i post a new video..

 

Anybody else have a 6 cyl thirdgen that lowered it?

 

Good topic. Can you also cover why most cars shake in the rear after lowering.

 

Interesting…I lowered mine and it doesn't shake one bit. But I did ensure my pinion angle was correct and added an adjustable pan hard bar with poly bushings…I'm adding LCARBS too.

I do have one issue the cropped up when I lowered mine…I'm using a UMI TQ arm, and the rear e-brake cable rode up against the top of the arm. I need to either add another guide and lengthen the cable slightly, or go with a shielded cable.

Might not be an issue at all if you use the stock TQ arm….

 

Great vid!!! Thanks! Only one thing, I have a torque wrench and usually torque everything to spec.. Does it matter if you didn't do it here?

 

Yeah torque wrench is fine..dont mind me , experience has taught me how much to tighten things down over the years..

Rear hops sometimes when putting rear coil overs in ..