Ball Joint doesn't fit right
Thread Starter
Member
Joined: Jan 2009
Posts: 279
Likes: 0
From: Charleston, SC
Car: 87 T/A
Engine: 400SBC Carb'd
Transmission: T56, Kevlar clutch
Axle/Gears: 3.73 Yukon Duragrip posi
Ball Joint doesn't fit right
I have my ball joints replaced a couple months ago, and had one break, then the same (new) one loosen WAY up TWICE (like, the castle nut, not the joint itself).
I took a look at it yesterday, and it was loose again, since the shop tightened it up 3 weeks ago. Turns out, the castle nut sits way too low on the "bolt." It can loosed way up, before it get's near the cotter pin.
Hence, why it keeps loosening way up. The cotter pin does no good, until it's already so loose it's dangerous.
I have NO idea why this is. Is there supposed to be a huge washer or spacer there or something??
I took a look at it yesterday, and it was loose again, since the shop tightened it up 3 weeks ago. Turns out, the castle nut sits way too low on the "bolt." It can loosed way up, before it get's near the cotter pin.
Hence, why it keeps loosening way up. The cotter pin does no good, until it's already so loose it's dangerous.
I have NO idea why this is. Is there supposed to be a huge washer or spacer there or something??
Supreme Member
Joined: Jun 2011
Posts: 2,036
Likes: 5
From: knoxville tn
Car: 86 IROC
Engine: 5.0 TPI
Transmission: 700-R-4
Axle/Gears: 2.73 open
Re: Ball Joint doesn't fit right
I have my ball joints replaced a couple months ago, and had one break, then the same (new) one loosen WAY up TWICE (like, the castle nut, not the joint itself).
I took a look at it yesterday, and it was loose again, since the shop tightened it up 3 weeks ago. Turns out, the castle nut sits way too low on the "bolt." It can loosed way up, before it get's near the cotter pin.
Hence, why it keeps loosening way up. The cotter pin does no good, until it's already so loose it's dangerous.
I have NO idea why this is. Is there supposed to be a huge washer or spacer there or something??
I took a look at it yesterday, and it was loose again, since the shop tightened it up 3 weeks ago. Turns out, the castle nut sits way too low on the "bolt." It can loosed way up, before it get's near the cotter pin.
Hence, why it keeps loosening way up. The cotter pin does no good, until it's already so loose it's dangerous.
I have NO idea why this is. Is there supposed to be a huge washer or spacer there or something??
Thread
Thread Starter
Forum
Replies
Last Post
Street Lethal
Power Adders
634
Apr 30, 2019 12:14 PM
Thirdgen89GTA
NW Indiana and South Chicago Suburb
0
Aug 20, 2015 03:11 PM
NBrehm
Engine/Drivetrain/Suspension Parts for Sale
0
Aug 5, 2015 07:57 PM