Joined: Aug 2009

Posts: 89

Likes: 0

Car: 1991 camaro z28 convertible

Engine: 5.0 v8

Transmission: 700r4

Axle/Gears: 9 bolt 3.23 borg worner

So I’m almost finished with the ford 9 inch install, the rear is from trick chassis and I got an adjustable torque arm from umi, the problem is wich ever way I try to bolt it down the mounting bracket on the torque hits the rear.. has anyone ever used this combo? Or have any ideas on what to do

Joined: Aug 2006

Posts: 12,807

Likes: 108

From: Central NJ

Car: 86 Trans Am

Engine: 408 stroker sbc

Transmission: TKO600

Axle/Gears: Moser full floater m9, 3:70 trutrac

Joined: Aug 2009

Posts: 89

Likes: 0

Car: 1991 camaro z28 convertible

Engine: 5.0 v8

Transmission: 700r4

Axle/Gears: 9 bolt 3.23 borg worner

well the mount on the torque arm has 4 bolt holes, And the pictures in the instructions use the 2 bolt holes closest the passenger side when I try to mount it on the support of the rear the mount in the torque arm hits one of the bolts for the support, if I use the 2 closets to the driver side then it hits the center section of the rear

Joined: Aug 2009

Posts: 89

Likes: 0

Car: 1991 camaro z28 convertible

Engine: 5.0 v8

Transmission: 700r4

Axle/Gears: 9 bolt 3.23 borg worner

Got it, had to grind down some of the bracket for the torque arm and everything fell into place