Are there different lower control arms?
#1
Junior Member
Thread Starter
Are there different lower control arms?
Are there different size lower control arms? I pulled a k frame and control arms from a 91 Camaro with a tbi V8 engine. I wanted to use this for my 91 Trans Am (5.7). When I went to press in the new bushings the rear bushing was too big for the hole. Front is fine. The bushing is 1.900 of an inch. The OUTER sleeve measurement of the hole is 1.828. There is no way this fits in there. They do not list a different bushing in any replacement parts I see. Any one have any insight on this?
#2
Moderator
iTrader: (5)
Re: Are there different lower control arms?
Check the following link for A-arm info:
https://www.thirdgen.org/forums/susp...s-created.html
JamesC
https://www.thirdgen.org/forums/susp...s-created.html
JamesC
Thread
Thread Starter
Forum
Replies
Last Post
dusty's89
Suspension and Chassis
6
11-22-2011 07:18 AM
DuronClocker
NW Indiana and South Chicago Suburb
3
10-19-2004 09:10 PM