REAL Quick STB question
Thread Starter
Supreme Member
iTrader: (2)
Joined: Nov 2000
Posts: 1,295
Likes: 0
From: California
Car: 1988 Camaro Convertible
Engine: 355
Transmission: 700r4
REAL Quick STB question
Hello,
I just need to know if the Edelbrock TPI STB will fit on an LS1 in a thirdgen? If it will fit a super ram I am guessing it will, but an LS1 sits about a half an inch higher than a TBI.
Thanks guys,
James
I just need to know if the Edelbrock TPI STB will fit on an LS1 in a thirdgen? If it will fit a super ram I am guessing it will, but an LS1 sits about a half an inch higher than a TBI.
Thanks guys,
James
Senior Member
Joined: Oct 2000
Posts: 659
Likes: 0
From: Chesapeake, VA
Car: '86 TransAm WS6
Engine: 305 TPI
Transmission: Custom TH700R4
Dunno about the Super Ram, but the Edelbrock STB only clears the top of the stock TPI intake by about 1/4 of an inch. I would check out the BMR Fabrication brace, it looks like it has a the clearance you're looking for.
Thread Starter
Supreme Member
iTrader: (2)
Joined: Nov 2000
Posts: 1,295
Likes: 0
From: California
Car: 1988 Camaro Convertible
Engine: 355
Transmission: 700r4
Thanks. I am going to call them tomorrow. The guys installing the LS1 said they could custom fab one, but we all know how much that would cost...
Thanks again
James
Thanks again
James
Thread
Thread Starter
Forum
Replies
Last Post