Okay, here it is. 330hp 350 crate engine with the vortec air gap intake, 1/2" adaptor plate, holley 670cfm, 5.0HO dual snorkel intake. Is there room for the air gap intake? How about the performer RPM? I know the performer has room.

------------------
, Jon (91 RS too many mods to list), getting new engine in summer

 

I don't think it will be a problem, although your getting close. Good excuse to buy a new fiberglass hood if you ask me. You'll get a litte weight savings there as well. The performer rpm should fit under stock hood. If it is dead nuts close, you can remove the hood insulation for a little more room.

------------------
Jerry

-------------------------
89 RS Lt Blue T-Tops T5
355 Crate, Compucam 2040
Pst Front Hotchkis Rear
Edle. TES 3" Flowmaster
Harwood hood, bla, bla, bla...
94 Z28, LT1 6M, Black
Most of the bolt-ons
-------------------------

 

The fiberglass hood is a good idea. Since my new job is payint me $23-27 an hour I think I'll be able to afford a new hood. I'm going to be shaving the door handles/locks/antenna and the front end need repainting BAD. Sounds like a good idea. air gap here I come. It's not that more expensive than the RPM.

------------------
, Jon (91 RS too many mods to list), getting new engine in summer