I have been looking at buying an Edelbrock Torker II intake, but I know that this will not bolt up to my stock heads. What do I need to do for it to bolt up?

I plan on hooking up to this a 670 Holley TBI I own, do you think this is the best choice in intake? If not what?

I know this may sound like a lot of carburation but I have big plans for this little 305.
Thanks,
Jordan


------------------
1990 Iroc
Canadian Iroc (305 TBI)
-14x3 open element
-Accel: Coil, Wires, Cap&Rotor
-B&M stage 2 shift Kit
- 4 255/50/ZR16 BFGoodrich Comp TA's
-Hypertech chip, low temp thermostat and fan switch
-1.6 ratio roller rockers
-3" exuast: High flow cat, meanstreak muffler, dual 2.5" outlets

 

I like mine (i run the torkerII) The center two bolt holes will need to be elongated some so that you can bolt it to the later style heads