i did the thing with tripping the aldl..worked perfect..great instructions :hail: ...anyway ive got codes:
34-MAP sensor voltage high/pressure high vacuum low
34-MAF signal high-FLow low
42-EST circuit grounded (HEI module failure)
44-oxygen sensor lean error
45-oxygen sensor rich error

help me fix these so my car can stop stallin in tha middle of tha road

 

Sounds to me like the first thing you should do is clear all those, and start over. It's pretty hard to troubleshoot a lean condition and a rich condition at the same time, for example; they may have occurred under totally different conditions over who knows how much time.

 

how do i do that?

 

Easiest way is to disconnect the negative battery wire for a little bit and connect it again. Or if you don't want to lose stations or time on your radio or whatever there is a ecm power line around the battery you can unclip.

 

grenrally multiple codes like that are a ECM going out . first try clearing and see what comes back first .

mike

 

I seriously doubt your ecm is bad. That isn't even a lot of codes. You probably should change your oxygen sensor and reset the codes. You may need a new MAF, or a relay.

 

what year vehicle is it? what type of fuel system? TBI, Carb, or TPI? that would help to see if u have a MAF or MAP sensor. what if any, symptoms are you having? that would help diagnose the problem.