Did I fry my O2 sensor?
Thread Starter
Member
Joined: Sep 1999
Posts: 352
Likes: 0
From: Southern MD, USA
Did I fry my O2 sensor?
When I swapped in the 350 my O2 sensor wire connector was dangling against my headers and pretty much melted. Could the wire have touched the headers and fried the sensor? By the way my car has an EXTREMELY eratic idle and stalls frequently, but I still have the old computer(LO3). Now it's a 350 vortec with the 670 tbi and a 214/224 - .471/.491 cam.
------------------
88 firebird formula
350 Vortec TBI - IT RUNS.....kinda
Edelbrock performer 2116 - mild cam
My Formula
------------------
88 firebird formula
350 Vortec TBI - IT RUNS.....kinda
Edelbrock performer 2116 - mild cam
My Formula
TGO Supporter
iTrader: (2)
Joined: Jul 1999
Posts: 13,579
Likes: 9
From: Readsboro, VT
Car: 85 IROC-Z / 88 GTA
Engine: 403 LSx (Pending) / 355 Tuned Port
Transmission: T56 Magnum (Pending) / T5
Axle/Gears: 3.42 / ?
IF you have headers, now is a good time to move up to a heated oxygen sensor.
------------------
The IROC Homepage
<A HREF="http://www.rit.edu/~jli4307/camaro" TARGET=_blank>
View the restoration of an 85 IROC</A>
"I didn't know a bored out Ford could go so slow" -Shenandoah
------------------
The IROC Homepage
<A HREF="http://www.rit.edu/~jli4307/camaro" TARGET=_blank>
View the restoration of an 85 IROC</A>
"I didn't know a bored out Ford could go so slow" -Shenandoah
Thread
Thread Starter
Forum
Replies
Last Post
maksik7
Tech / General Engine
2
Jul 22, 2001 10:28 PM
