Ok, I am trying to finish the project I started a while ago and am pretty much finished. Though I was, but when I went to hook up the coil I found that I only had on of the connectors to it. I found the other on but am unsure where it goes. I have a pic, the connector on the left goes to the coil but where does the other one hook to.

 

I think that may be the one that goes from the coil to the distributor. I had the same problem when I swapped engines with those 3 wires.

 

Thanks for the reply.

I think you are right, I went through the wiring diagrams in the Haynes manual and I had the air temp sensor plugged into the dist . It seems I need a new temp sensor, the TPI and TBI aren’t the same. So that solves two problems.