this guy is confusing
Thread Starter
Member
Joined: Nov 2002
Posts: 405
Likes: 0
Car: 91 Camaro RS
Engine: 350
Transmission: 700R-4
this guy is confusing
Check this site out, http://www.mototuneusa.com/break_in_secrets.htm
I think this is for motorcyles, but still.
This guy has some funky *** ideas, and im thinking hes full of it. He says toward the bottom of the page that port and polihing is detremental to engine performance, and that smaller intake ports are better? I could understand that MAYBE cause its speeds up air through a smaller opening...but still.....what you think?
the break in sounds a bit off too. I know its good to go to 50 or so, then break back to slow, then do it again for a bit.....at least thats what a few racecar builders I konw say.
anyeway, cheers!
I think this is for motorcyles, but still.
This guy has some funky *** ideas, and im thinking hes full of it. He says toward the bottom of the page that port and polihing is detremental to engine performance, and that smaller intake ports are better? I could understand that MAYBE cause its speeds up air through a smaller opening...but still.....what you think?
the break in sounds a bit off too. I know its good to go to 50 or so, then break back to slow, then do it again for a bit.....at least thats what a few racecar builders I konw say.
anyeway, cheers!
Last edited by x_wolf; Sep 13, 2003 at 04:30 PM.
Thread
Thread Starter
Forum
Replies
Last Post
BurlyChev
Tech / General Engine
14
Aug 22, 2015 01:52 PM
