Does GM offer Chrome moly pushrods for roller motors? If so what is the part #? I hate to spend the 109.99 with Jegs or Summit. What can I say I am a bargain hunter. Thanks, Brandon

 

Bran,

P/N 10046173 (push rod set) has a heavy wall, low-chrome/steel alloy (1018) case hardened for use with or without guide plates on roller cammed engines. They have a heavier wall than production rods and are subsequently a bit heavier. They'll set you back about $25.00. These should handle most aftermarket cams in street engines.

You can probably do better on overall weight for a high RPM engine with 4140 alloy rods, but they'll cost you upwards of $150.00 from the big cam houses.

------------------
Later,
Vader
------------------
"No matter how hard you try you can't stop us now"
Adobe Acrobat Reader 4.0

 

Vader,
You are a life saver. Thanks a million, BranT

 

Hey, anything for someone from a place named after such a cool airplane (or was it the other way around?)

------------------
Later,
Vader
------------------
"No matter how hard you try you can't stop us now"
Adobe Acrobat Reader 4.0