How much will this take?
Thread Starter
Senior Member
Joined: Dec 2000
Posts: 550
Likes: 0
From: Alberta
Car: Red Rooster
Engine: 305 TPI
Transmission: M5
How much will this take?
How much torque/hp will the 89 5 spd and rear end take?
Thanks.
------------------
89Iroc, 305 TPI, WC T5, 3.08 Posi, Flowtech Headers 1 1/2, Hooker Y-Pipe 2 1/2, 3 inch over the axle, Flowmaster 80, No Cat, Aluminium Driveshaft, Ported Plenum, Air Foil, MAF Screens/Fins removed, K&N, Gutted Air Boxes, AFPR @45 psi, Ram Air, Throttle Body By-pass, Bumped Timing @12, Bosch +4, MSD 8mm wires, HP Rotor, Cap and Fuel Filter, Sensi Trac rear Shocks.
Thanks.
------------------
89Iroc, 305 TPI, WC T5, 3.08 Posi, Flowtech Headers 1 1/2, Hooker Y-Pipe 2 1/2, 3 inch over the axle, Flowmaster 80, No Cat, Aluminium Driveshaft, Ported Plenum, Air Foil, MAF Screens/Fins removed, K&N, Gutted Air Boxes, AFPR @45 psi, Ram Air, Throttle Body By-pass, Bumped Timing @12, Bosch +4, MSD 8mm wires, HP Rotor, Cap and Fuel Filter, Sensi Trac rear Shocks.
TGO Supporter
Joined: Aug 1999
Posts: 14,811
Likes: 1
From: Jackson County
there are several people on here that have taken the 7 1/2" ten bolt and t5 into the 11 second range with no problems.
------------------
ICON Motorsports
1st & 3rd
------------------
ICON Motorsports
1st & 3rd