How hard is it to get paint off of runners? Will I have to paint over them? They are red right now and I don't want them to be red.
Thanks

 

Should be able to take the paint off with carb cleaner and not stain the aluminum.

 

No it's high temp engine enamel. I dont think thats strong enough. Does anyone know what they use for the clearcoat on wheels?
thanks.

 

I used Aircraft paint remover to get the clearcoat and powdercoat off my rims, you can get it at AutoZone. It may work and may not. Worth a shot maybe?


Brendan

------------------
1987 IROC-Z L98 350 SuperRam, Edelbrock Performer 6085 Aluminum Heads, LPE RollerCam 219/219, Crane Gold Race 1.6RR, TF 1 pc Moly Pushrods, Underdrive Pulleys, Edelbrock TPI High Flow Base Manifold, Accel 58mm TB, ADS 24#, Crane AFPR, K&N, Edelbrock TES Headers, Catco Hi Flow Cat, 3" Borla Cat-Back, Accel Cap & Rotor, MSD 8.5mm, MSD 6AL Ignition, MSD Blaster 2 Ignition Coil, Hayes Clutch, 1LE Aluminum DS, 94' Z28 Disk Rear, Wilwood Adjustable Proportioning Valve, Torsen Series 3 Posi Carrier, Precision 3.73 Gears, Southside Machine Sub-Frame Connectors, Hotchkis Lower Control Arms, KYB Shocks/Struts, Suspension Techniques Lowering Springs, Polyurethan Bushings all over the place, Moog Upper/Lower Ball joints and Tie Rods ends/Idler Arm,

To see the ROC, Check out the webpage Here

 

thanks