Hydraulic Roller Cam
Thread Starter
Junior Member
Joined: Mar 2000
Posts: 6
Likes: 0
From: Fairfield, CA
Hydraulic Roller Cam
I just wanted to know if the 1988 Iroc 350s came with a hydraulic roller cam from the factory? And if it didn't, what type of setup did the Rocs have? Thanx for any info fellas.
*THOU SHALL GO FASTER
*THOU SHALL GO FASTER
Supreme Member
Joined: Jul 1999
Posts: 18,457
Likes: 16
From: Loveland, OH, US
Car: 4
Engine: 6
Transmission: 5
Supreme Member
Joined: Feb 2000
Posts: 1,196
Likes: 0
From: Fort Collins, Colorado
Yes, all TPI motors from I think 87 on had the hydraulic roller cams. I know that for sure your 88 has one because my 87 has one.
------------------
1987 Chevy Camaro IROC-Z
L98 TPI 350 (5.7L)
TH 700R-4 Transmission
Borg Warner 7.75" 9 Bolt Rear End
Current Mods: LT4 Hot Cam, Comp Cams 1.52:1 Roller Rocker Arms, Edelbrock TES 1 5/8" Headers, Hooker 3" Aerochamber Cat-Back System, Performance Resource Chip, Accel Ignition Coil, Cap, Rotor, 8.8mm Wires, K&N Filters, JET TPI Air Foil, All Free Mods, Falken ZIEX Z-Rated Tires.
Best ET (w/o LT4 cam): 14.32 @ 97.7mph
(corrected for elevation)
7.5" 10 Bolt with 3.42s soon to come!
------------------
1987 Chevy Camaro IROC-Z
L98 TPI 350 (5.7L)
TH 700R-4 Transmission
Borg Warner 7.75" 9 Bolt Rear End
Current Mods: LT4 Hot Cam, Comp Cams 1.52:1 Roller Rocker Arms, Edelbrock TES 1 5/8" Headers, Hooker 3" Aerochamber Cat-Back System, Performance Resource Chip, Accel Ignition Coil, Cap, Rotor, 8.8mm Wires, K&N Filters, JET TPI Air Foil, All Free Mods, Falken ZIEX Z-Rated Tires.
Best ET (w/o LT4 cam): 14.32 @ 97.7mph
(corrected for elevation)
7.5" 10 Bolt with 3.42s soon to come!
Thread
Thread Starter
Forum
Replies
Last Post