Torque Convertor
Thread Starter
Junior Member
Joined: Feb 2001
Posts: 20
Likes: 0
From: Middletown, New Jersey
Torque Convertor
Hey,
I want to get a new torque convertor for my car (1991 GTA 350) But I
cannot do the installation myself so I am going to have a shop do it. Any
estimates as to how much this will cost? Hours involved? Thanks bye
I want to get a new torque convertor for my car (1991 GTA 350) But I
cannot do the installation myself so I am going to have a shop do it. Any
estimates as to how much this will cost? Hours involved? Thanks bye
Senior Member
Joined: Feb 2000
Posts: 769
Likes: 0
From: Stillwater, OK
It's really easy. You can either spend $100-$200 to have someone install it, or find some buddies and buy the beer.
Have you ever pulled a tranny before?
Pull the driveshaft, drain the fluid,loosen the flexplate,bellhousing,fluid lines,kickdown,etc.
Twist the old stall off, add the new one on. Most go in two to three intervals, and re-assemble.
But you'll love adding one either way!
------------------
350 4 bolt main, Speed-O-Motive 383 stroker kit, re-sized rods ground for clearance,TRW Forged pistons,10.7:1 compression,HPC Coated RPM intake, Speed Demon 750 cfm carb,World Products Sportsman II heads,2.02/1.60 valves, Comp Cam 1.6 roller rockers, Comp Xtreme 284 cam,240/246@.050 with .540 lift,Crane pushrods,ATI damper,Proform HEI and MSD6A box,HPC coated 1 5/8 headers, 2.5" exhaust with 40 series mufflers,TH350 with B&M 3000 stall, Powertrax NoSlip Locker, 4.11 gears.
Have you ever pulled a tranny before?
Pull the driveshaft, drain the fluid,loosen the flexplate,bellhousing,fluid lines,kickdown,etc.
Twist the old stall off, add the new one on. Most go in two to three intervals, and re-assemble.
But you'll love adding one either way!
------------------
350 4 bolt main, Speed-O-Motive 383 stroker kit, re-sized rods ground for clearance,TRW Forged pistons,10.7:1 compression,HPC Coated RPM intake, Speed Demon 750 cfm carb,World Products Sportsman II heads,2.02/1.60 valves, Comp Cam 1.6 roller rockers, Comp Xtreme 284 cam,240/246@.050 with .540 lift,Crane pushrods,ATI damper,Proform HEI and MSD6A box,HPC coated 1 5/8 headers, 2.5" exhaust with 40 series mufflers,TH350 with B&M 3000 stall, Powertrax NoSlip Locker, 4.11 gears.
Thread
Thread Starter
Forum
Replies
Last Post
no green
Engine/Drivetrain/Suspension Parts for Sale
11
Jan 9, 2016 09:22 PM
