Scanner Test
Thread Starter
Member
Joined: Feb 2001
Posts: 129
Likes: 0
From: eastbay,cal.
Scanner Test
I did a test on my car to see if it is going into closed loop. When I first started it it shows open loop then after a minute or so it will go into closed loop but only when I have the car at 2000 rpms,if it falls below that or at idle I do not get any flashing light at all. What does that mean? I have a fastchip stage two, and SLP headers. I am planing on changing 02 sensor anyway. Thanks for any info.
------------------
SLP 1 5/8 Headers,ATR catback exhaust,SLP cold air box,Crane 1:6 roller rockers,Bosch plugs and MSD wires,MSD Coil,Fastchip,Borg Warner 9 bolt 3:27,Corvette Servo,ROH ZS 17X9.5 Goodyear GSC,s 275/40/17
------------------
SLP 1 5/8 Headers,ATR catback exhaust,SLP cold air box,Crane 1:6 roller rockers,Bosch plugs and MSD wires,MSD Coil,Fastchip,Borg Warner 9 bolt 3:27,Corvette Servo,ROH ZS 17X9.5 Goodyear GSC,s 275/40/17
Thread
Thread Starter
Forum
Replies
Last Post
RedLeader289
Tech / General Engine
10
May 28, 2019 01:47 PM
