Well I am putting the bottom of the car together today and I pluged in the Torque converter harness to the tranny and I found a two prong plug coming out of that harness and I have no idea where It goes (not the o2 checked that) I can't find anyting else down there and its wires are not long enoughh to get back up to the motor


Thanks again
Brian Felts

 

What color wires?

------------------
"So many Mustangs, so little time..."
ICON Motorsports

 

Purple and yellow


THANKS
B

 

Sounds like starter safety switch, maybe on the shifter, especially if they're real thick wires

------------------
"So many Mustangs, so little time..."
ICON Motorsports

 

Well the wires are short about 6 to inches. I did install a Megashifter a while back could that be it?? I just can't see anything near the block or the tranny that has any connector (or two prong) I got the Torque converter 4 prong, the o2, the little one on the driver side head that goes into the water passage but now I am lost.....

any other opinion or could it have been a never used plug.

Thanks again......

Brian

 

Are they thick wires? Could they plug into the shifter area? If so, that's what they are. Yellow = power from the ignition switch START contact, purple = wire that goes to solenoid

------------------
"So many Mustangs, so little time..."
ICON Motorsports

 

yeah they are kinda thinck I would guess. Did we do away with the terminal when we went to the mega shifter....


THANKS AGAIN
Brian

 

Brian check and see if it goes to your speedometer sennding unit located close to the driver side tail housing hooked mine up today i hope this helps if not e-mail or post!!

------------------

 

NO nothing on the speedo........it has a cable driven one. I am lost but I think the best idea was the neutral safety switch... I have no idea.


Thanks
Brian