Tech / General Engine Is your car making a strange sound or won't start? Thinking of adding power with a new combination? Need other technical information or engine specific advice? Don't see another board for your problem? Post it here!
Sponsored by:
Sponsored by: CARiD

Timing On TBI

Thread Tools
 
Search this Thread
 
Old May 31, 2001 | 04:08 PM
  #1  
Brian Felts's Avatar
Thread Starter
Senior Member
 
Joined: Jul 1999
Posts: 760
Likes: 0
From: Chillicothe Ohio
Car: 89 RS 355/ 89 IROC Convert
Engine: Hot Cam 355/TPI 305
Transmission: All 700r4's
Timing On TBI

OK here we go........Got the Dist in and the car set on TDC. I know to pull the plug on the passenger firewall then the car dies......What am I doing wrong???? What is the process for stetting the base timing?

Brian

------------------
1989 Camaro RS

305 .030 over Hydro Pistons
Vortech heads milled to 58cc...Performer RPM intake....LT4 cam..Crane Gold rockers...FastChip custom chip...ALum. Driveshaft...3.73 gears with Posi...underdrive pullys...Rebuilt 700R4 with Vette Servo and B&M shift Kit...MSD ignition...A/C Delete No SMOG junk....1997 SS leather interior...B&M Shifter... Ultimate TBI mods...14X3 K&N open Element Non-Drop...Hooker headers....3" exhaust with Flowmaster Cross flow 16X8 Wheels from 97 RS Spohn LCA's Spohn Panhard Bar..LETS PLAY FORD!!
Reply
Old May 31, 2001 | 04:13 PM
  #2  
BahamutRS's Avatar
Member
 
Joined: Apr 2001
Posts: 462
Likes: 0
From: Parlin, NJ
Just curious, what does your car do in the 1/4 mile?
Reply
Old May 31, 2001 | 05:17 PM
  #3  
Brian Felts's Avatar
Thread Starter
Senior Member
 
Joined: Jul 1999
Posts: 760
Likes: 0
From: Chillicothe Ohio
Car: 89 RS 355/ 89 IROC Convert
Engine: Hot Cam 355/TPI 305
Transmission: All 700r4's
THis is the first startup On the motor. I will post that on down the line.


Brian

------------------
1989 Camaro RS

305 .030 over Hydro Pistons
Vortech heads milled to 58cc...Performer RPM intake....LT4 cam..Crane Gold rockers...FastChip custom chip...ALum. Driveshaft...3.73 gears with Posi...underdrive pullys...Rebuilt 700R4 with Vette Servo and B&M shift Kit...MSD ignition...A/C Delete No SMOG junk....1997 SS leather interior...B&M Shifter... Ultimate TBI mods...14X3 K&N open Element Non-Drop...Hooker headers....3" exhaust with Flowmaster Cross flow 16X8 Wheels from 97 RS Spohn LCA's Spohn Panhard Bar..LETS PLAY FORD!!
Reply
Old May 31, 2001 | 05:22 PM
  #4  
Pukka's Avatar
Supreme Member
 
Joined: Jul 2000
Posts: 1,341
Likes: 0
From: Where the chicks absolutely LOVE the V-8 rumble!
Car: 92 RS - Fully Restored w/Custom Int
Engine: LO3 with some mods
Transmission: T-5
Axle/Gears: 3.42 Richmond
I'm not sure if you meant that you pulled the EST bypass wire after you started it. If you did then either connect it or disconnect it BEFORE starting

------------------
92 Camaro RS, LO3, 5-spd, T-tops

Performance:
K&N Open Air Filter, Edelbrock performer TBI intake, Fastchip Prom, Timing +4 degrees, Centerforce clutch, Xact 8mm wires, SLP 1 3/4" Headers (coated), Flowmaster Catback Exhaust, Z28 Grille w/aftmkt fog lamps, MacEwen white-face guages
Electronics:
Alpine 8030 Alarm System, Valentine One Radar Detector (How did I ever drive without one?), Pioneer DEH 7450 Head Unit w/6-pack CD changer, Pioneer DEQ 7600 Sound Processor, 2 Kenwood KAC-846 Amps powering 2 12" Pro Red subs, 2 Pioneer 6x9 and 2 MTX 4x6 speakers.
NEXT UP: TBI mods, 3.42 gears w/Torsen posi
Reply
Old May 31, 2001 | 08:44 PM
  #5  
Brian Felts's Avatar
Thread Starter
Senior Member
 
Joined: Jul 1999
Posts: 760
Likes: 0
From: Chillicothe Ohio
Car: 89 RS 355/ 89 IROC Convert
Engine: Hot Cam 355/TPI 305
Transmission: All 700r4's
Thanks I was pulling after the motor was running!!!

Is this wrong???


Brian

------------------
1989 Camaro RS

305 .030 over Hydro Pistons
Vortech heads milled to 58cc...Performer RPM intake....LT4 cam..Crane Gold rockers...FastChip custom chip...ALum. Driveshaft...3.73 gears with Posi...underdrive pullys...Rebuilt 700R4 with Vette Servo and B&M shift Kit...MSD ignition...A/C Delete No SMOG junk....1997 SS leather interior...B&M Shifter... Ultimate TBI mods...14X3 K&N open Element Non-Drop...Hooker headers....3" exhaust with Flowmaster Cross flow 16X8 Wheels from 97 RS Spohn LCA's Spohn Panhard Bar..LETS PLAY FORD!!
Reply
Related Topics
Thread
Thread Starter
Forum
Replies
Last Post
MustangBeater20
TBI
11
Oct 29, 2022 09:20 PM
evilstuie
Tech / General Engine
22
Jan 9, 2020 08:29 PM
justin57
TBI
30
Aug 20, 2015 07:05 PM




All times are GMT -5. The time now is 08:43 PM.