Torque for Knock Sensor?
Thread Starter
Banned
iTrader: (1)
Joined: Feb 2000
Posts: 1,198
Likes: 1
From: Bound Brook, NJ USA
Car: 89 IROC-Z
Engine: 383
Transmission: 700R4
Torque for Knock Sensor?
Is there a specific torque value for installing the knock sensor? It's in an 89 350.
------------------
Riccioli Performance Motorworks
--RPM Racing--
-Currently building first ever engine. 383 with Super Ram plenum and runners, Edelbrock lower intake, Bosch 24# injectors, AFR 190 heads, MSD ignition.
-Will be installing Baer Brakes
-Will be installing full Spohn suspension in rear
-Art Carr 700R4 trans??
Attention Everyone!!! I will be changing my name on the message boards to HardcoreZ28 sometime in the near future. Just wanted to let everyone know.
------------------
Riccioli Performance Motorworks
--RPM Racing--
-Currently building first ever engine. 383 with Super Ram plenum and runners, Edelbrock lower intake, Bosch 24# injectors, AFR 190 heads, MSD ignition.
-Will be installing Baer Brakes
-Will be installing full Spohn suspension in rear
-Art Carr 700R4 trans??
Attention Everyone!!! I will be changing my name on the message boards to HardcoreZ28 sometime in the near future. Just wanted to let everyone know.
Moderator
Joined: Jan 2000
Posts: 19,655
Likes: 309
Paul,
You getting any closer yet?
My manual says 14 ft-lbs (19 Nm) for the detonation sensor. I think that sounds about right. (Good guess, Mike!)
------------------
Later,
Vader
------------------
"Let the bodies hit the floor!"
Adobe Acrobat Reader
You getting any closer yet?
My manual says 14 ft-lbs (19 Nm) for the detonation sensor. I think that sounds about right. (Good guess, Mike!)
------------------
Later,
Vader
------------------
"Let the bodies hit the floor!"
Adobe Acrobat Reader
Thread
Thread Starter
Forum
Replies
Last Post
Ragtop Man
Transmissions and Drivetrain
2
Sep 12, 2015 12:23 AM
FormulasOnly
Tech / General Engine
3
Sep 10, 2015 09:07 PM