What prices would i be looking at to have a 350 Block Bored .030" over, and having heads ported?

 

Boring a block is usually around $10-12 a hole. Porting heads depends on how far you want to go. A basic pocket port should cost $300-$400 not including a valve grind or any other machine work that may be required.

------------------
Follow my racing progress on Stephen's racing page
and check out the race car

87 IROC-Z SuperPro ET Bracket Race Car
461 naturally aspirated Big Block

Best ET on a time slip: 11.242 altitude corrected to 10.89
Best MPH on a time slip: 121.52 altitude corrected to 125.89
Altitude corrected rear wheel HP: 497.9
Best 60 foot: 1.546

Racing at 3500 feet elevation but most race days it's over 5000 feet density altitude!
Member of the Calgary Drag Racing Association

87 IROC bracket car, 91 454SS daily driver, 95 Homebuilt Harley

 

if i remember the costs on my motor..
the shortblock work, tanking pressurechecking,align boring, boring and honing, and decking the block were around 500 bucks.
The bowl work, valve jobs, and guides for the vortec heads were around 500 bucks. the springs pressure checking and installation were about another 75.