passenger side header glowing?
passenger side header glowing?
OK, got my new tranny in and took my Z out for a spin. I ran 3 good hard runs giving 8psi. Drove it right home into the garage. I turned off the lights, opened the hood and noticed my passengers side header collector was glowing red. The header was glowing red at the collector after hard excelleration.
WHY?
It was not red on the drivers side, but it was on the collector where it mates to the Y pipe? Any ideas? Timing is set at 8deg. advanced, just replaced the IAC, no codes.
WHY?
It was not red on the drivers side, but it was on the collector where it mates to the Y pipe? Any ideas? Timing is set at 8deg. advanced, just replaced the IAC, no codes.
Last edited by IROCBlueZ28; May 5, 2005 at 10:48 PM.
Banned
iTrader: (4)
Joined: Dec 2000
Posts: 861
Likes: 0
From: ILL
Car: 1986 Pontiac TA
Engine: 383
Transmission: 700R4
Axle/Gears: 3.70
You have a lean mixture.
A wide band A/F meter is an invaluable tool. With the set up you have, I highly recommend getting one. Innovate Motorsports has an affordable unit.
Good luck.
www.geocities.com/dzperf
A wide band A/F meter is an invaluable tool. With the set up you have, I highly recommend getting one. Innovate Motorsports has an affordable unit.
Good luck.
www.geocities.com/dzperf
Thread
Thread Starter
Forum
Replies
Last Post





