Knock Sensor Info
Thread Starter
Supreme Member
Joined: Aug 2002
Posts: 3,827
Likes: 1
From: Gainesville, FL
Car: 1988 Chevy Camaro Hardtop
Engine: Turbocharged/Intercooled 3.1
Transmission: World Class T5 5 Speed
Knock Sensor Info
On the '730 equipped cars, is there still an external ESC module, or is that in the Memcal?
In other words, if I were wiring up a knock sensor, would I simply run a wire from the sensor to pin B7?
In other words, if I were wiring up a knock sensor, would I simply run a wire from the sensor to pin B7?
Moderator
Joined: Feb 2000
Posts: 7,015
Likes: 2
From: Schererville , IN
Car: 91 GTA, 91 Formula, 89 TTA
Engine: all 225+ RWHP
Transmission: all OD
Axle/Gears: Always the good ones
Its in the memcal.
Should be a few wasy posted about using the old sensors with the new system thru resistors and the sort.
Not sure if it applies to the v6 cars however.
later
Jeremy
Should be a few wasy posted about using the old sensors with the new system thru resistors and the sort.
Not sure if it applies to the v6 cars however.
later
Jeremy
Thread Starter
Supreme Member
Joined: Aug 2002
Posts: 3,827
Likes: 1
From: Gainesville, FL
Car: 1988 Chevy Camaro Hardtop
Engine: Turbocharged/Intercooled 3.1
Transmission: World Class T5 5 Speed
My engine was originally a 2.8/MAF system... I pulled the 2.8 and the MAF system, and am wiring a 3.1 into place, and I want to be sure that I just run a wire from the knock sensor to the ECM 
Thread
Thread Starter
Forum
Replies
Last Post
FormulasOnly
Tech / General Engine
3
Sep 10, 2015 09:07 PM
