i just ordered a set of these with 190cc runners, does it seem like a good deal for a mild street motor?


http://cgi.ebay.com/ebaymotors/ws/eB...AFSEL%3AUS%3A1


i also got headbolts,cm pushrods, stainless full roller rockers and gaskets from him. all for $1000 shipped. now i just need to get the comp. xe 274 ordered.

 

The link describes them as 210cc ports. Is the seller offering 190's as well?

They sound fine for a mild street engine if they are 190's.

 

Those look like another version of the former of the pro-topline heads. If you havent gotten them yet you might notice the ports might be oddly sized. A few people on this board had to do considerable port matching to make them work with just about any intake since they are neither a 1205 or a 1206. See if this looks similar.

https://www.thirdgen.org/techbb2/sho...t=topline+1206

 

he has 35 sets of 210's and 3 190's. i called him to see if he had any 190's. after reading about a thousand posts i knew 210's would be too big for what i wanted. $1100+ was just more than i wanted to spend on afr or tfs.

he is sending me fel pro 1206 with them. he did tell me that with my holley intake i might have to do some port matching. he has 700+ positive feedbacks and no neg. on all kinds of car parts so i should be ok.

 

Well when you get them why dont you post pics of them with the 1206 gaskets laying on them. Dont be surprised to find this.

 

would those heads be ok for a retro roller setup?