Anyone put truck heads on their 350?
Thread Starter
Member
Joined: May 2004
Posts: 169
Likes: 1
From: Lyndonville, VT
Car: 89 Firebird Formula
Engine: Custom Forged 402ci LS2 w/STS Turbo
Transmission: T56 6-speed
Axle/Gears: Moser 9" with 4.11
Anyone put truck heads on their 350?
I've got a 350 TPI engine I pulled from my Formula that I am going to rebuild.
First off, I'm probably going to sell the TPI setup, and switch to a carb.
Secondly, I have a set of Vortech heads off my 97 Silverado 305 engine that died last year.
Anyone ever tried putting 305 truck Vortechs on an L98 engine?
I'm assuming the compression will probably go up, but will they flow enough for a 350? (Especially if I go carb?)
Anyone who has any insight, please share.
First off, I'm probably going to sell the TPI setup, and switch to a carb.
Secondly, I have a set of Vortech heads off my 97 Silverado 305 engine that died last year.
Anyone ever tried putting 305 truck Vortechs on an L98 engine?
I'm assuming the compression will probably go up, but will they flow enough for a 350? (Especially if I go carb?)
Anyone who has any insight, please share.
Supreme Member
iTrader: (2)
Joined: Jul 2004
Posts: 1,678
Likes: 0
From: Miami
Car: 1992 Camaro RS
Engine: L03
Transmission: 700R4
Axle/Gears: Stock
From what I hear, truck heads are good for bottom end torque. But that's about it. And they'll probably do more harm than good on a 350.
Thread
Thread Starter
Forum
Replies
Last Post
NinjaNife
Tech / General Engine
27
Aug 23, 2015 11:49 AM
