350 TPI w/ 4 speed ???
Thread Starter
Member
Joined: Jul 2005
Posts: 460
Likes: 0
From: Jacksonville, Florida
Car: 1992 Camaro Z28
Engine: 5.7 LT1
Transmission: 4L60
Axle/Gears: 3.23's
350 TPI w/ 4 speed ???
After I pulled out my 350 TPI for my LT1 swap, me and my buddy are deciding to put the leftover TPI in our 2.8 87 Camaro beater. I have all of the wiring, harness etc. The 87' has the 2.8v6 with a 4 speed standard. Will the TPI bolt up to this ? and if it does how long will the 4 speed last under the torque of the TPI ??
Supreme Member
Joined: Jul 2005
Posts: 2,123
Likes: 0
From: North Central Mass.
Car: 1985 Berlinetta
Engine: Megasquirted TPI
Transmission: Transgo 700R4
Axle/Gears: 3.42
no. The v6 is a 60 degree motor and the v8 a 90 degree motor. The transmissions will not work.
Supreme Member
iTrader: (1)
Joined: Jul 2004
Posts: 10,763
Likes: 4
From: Calgary, AB, Canada
Car: 1982 Trans-Am
Engine: 355 w/ ported 416s
Transmission: T10, hurst shifter
Axle/Gears: 10 bolt, true-trac, 3.73
you could use the trans that was mounted to that 350 TPI motor right? since you're using the new T56 that came with the LT1?
Thread Starter
Member
Joined: Jul 2005
Posts: 460
Likes: 0
From: Jacksonville, Florida
Car: 1992 Camaro Z28
Engine: 5.7 LT1
Transmission: 4L60
Axle/Gears: 3.23's
Ya I guess were gonna do that, we wanted to use the 4 speed but since it wont bolt up right, were gonna use the 700r4.
Thread
Thread Starter
Forum
Replies
Last Post
Pac J
Tech / General Engine
3
May 17, 2020 10:44 AM
Hotrodboba400
Firebirds for Sale
3
Dec 10, 2019 07:07 PM
Hotrodboba400
Firebirds for Sale
0
Sep 2, 2015 07:28 PM
