Vortec Rockers
Thread Starter
Senior Member
iTrader: (5)
Joined: May 2005
Posts: 831
Likes: 1
From: Midwest IL
Car: 1984 Z28
Engine: Alky 360
Transmission: TH400, Freakshow 9.5"
Axle/Gears: 9" 4.71
Vortec Rockers
I know that this has probably been covered somewhere before but i can't seem to find it so i thought that i would ask. What are the reasons for the self-aligning rocker arms on vortec heads? I thought that i had read somewhere that if you switched over to a aftermarket screw in stud that they were no longer necessary. Is this right?
Thanks!!!
Thanks!!!
Supreme Member
iTrader: (5)
Joined: Jan 2002
Posts: 13,622
Likes: 5
From: Orland Park, IL
Car: 1984 Z28
Engine: SLOW carbed ls
Transmission: TH400 with brake, 8" PTC converter
Axle/Gears: moser 9" 4.11
i switched to screw in studs and then used guideplates along with non-self aligning aka "normal" rockers
Thread
Thread Starter
Forum
Replies
Last Post
New2Chevy
Engine/Drivetrain/Suspension Parts for Sale
2
Sep 28, 2015 12:35 AM
monte87cortez
Transmissions and Drivetrain
2
Sep 26, 2015 08:10 PM
