will this cam work with my chevy 400?
Thread Starter
Member
Joined: Jun 2006
Posts: 334
Likes: 0
From: Shangri-La
Car: 87 Iroc
Engine: 305 TPI
Transmission: 700R4
Axle/Gears: stock posi
will this cam work with my chevy 400?
hey guys, im putting a chevy 400 in my 87 Iroc, its got 202 heads on it, im getting the holley stealth ram intake for it also, along with headers/dual exhaust. and a custom chip eventually. will this cam from summit work well with this motor?
Summit Camshafts: SUM-1107 - summitracing.com
by the way, im getting new rods for the engine to.
Summit Camshafts: SUM-1107 - summitracing.com
by the way, im getting new rods for the engine to.
Joined: Sep 2005
Posts: 27,916
Likes: 2,448
Car: Yes
Engine: Usually
Transmission: Sometimes
Axle/Gears: Behind me somewhere
There are very few cams you could pick that would be any more EFI-hostile than that one, at its level of performance; or looked at from the flip side, very few that would perform any more poorly at the same level of tuning difficulty.
It's definitely a contenda for a last-place award.
It's definitely a contenda for a last-place award.
Thread Starter
Member
Joined: Jun 2006
Posts: 334
Likes: 0
From: Shangri-La
Car: 87 Iroc
Engine: 305 TPI
Transmission: 700R4
Axle/Gears: stock posi
so your saying its a bad cam? where could i get a very good performance cam for pretty cheap that would go good with my application?
Member
Joined: Aug 2006
Posts: 256
Likes: 0
From: indiana
Car: 86 Z-28
Engine: 355 small block XR276HR roller cam
Transmission: TCI built 700r4 2000 lockup stall
Axle/Gears: moser axels auburn posi 3:73 gears
call a cam company suck as comp crane so on so on and then tell them what your aplication is going to be then come back an through it at these guys they all seem pretty knowledgeable
Thread
Thread Starter
Forum
Replies
Last Post
