heater core hose relocation
Thread Starter
Junior Member
Joined: Feb 2007
Posts: 73
Likes: 0
From: lynchburg
Car: 84z
Engine: 305 HO carb
Transmission: 700r4
Axle/Gears: stock
heater core hose relocation
there are 2 hoses coming from the front of my engine (one is hooked up to the intake manifold i think)that i need to relocate, if i can. both go into the firewall, so i assume it is for the heater. im cleaning up my engine bay, and im removing the AIR system, and now i have these two rubber hoses going over my left valve cover...
if anyone can help me to relocate them or at least tell me what they do and are for it would be appreciated...thanks
if anyone can help me to relocate them or at least tell me what they do and are for it would be appreciated...thanks 
Joined: Feb 2002
Posts: 3,462
Likes: 4
From: N. Illinois
Car: 92 GTA/ 00 TA
Engine: 383/350
Transmission: 700R4/T-56
Re: heater core hose relocation
They do go to the heater core.
You can just extend the hoses with couplers to get them out of the way. You could even just take the heater core out of the mix (no heat) and re-route. That'd be the cleanest.
You can just extend the hoses with couplers to get them out of the way. You could even just take the heater core out of the mix (no heat) and re-route. That'd be the cleanest.
Supreme Member
Joined: Mar 2002
Posts: 4,812
Likes: 0
From: 62656
Car: 1991 S10 pickup 2700lbs
Engine: 4.3L Z TBI
Transmission: 700R4
Axle/Gears: 3.08 7.625"
Re: heater core hose relocation
if you rmeove them then you can use a regular old plumbing pipe plug to plug the hole in the waterpump
but how to plug off the radiator one is up to you
good luck
but how to plug off the radiator one is up to you
good luck
Thread
Thread Starter
Forum
Replies
Last Post
