Electric Dual Fan Problems
Thread Starter
Supreme Member
Joined: Oct 1999
Posts: 2,977
Likes: 1
From: Davison / Troy ,Michigan
Car: 1991 Pontiac Firebird
Engine: 3.8
Transmission: 700r4
Axle/Gears: Dana 60
Electric Dual Fan Problems
Hooking stuff back up after the motor swap, I seem to have an empty plug that comes from the dual fan setup (Spal). The fan runs 2 different clumps of wires off it's harness. One is going into the actual engine harness, what appears to be coming into the firewall (Pass side) and then there is this plug labeled PAD. Here is a picture of the plug.
Where exactly does this go? I can't find anything anywhere to plug into and I haven't seen the fans turn on yet. Any help would be appreciated.
Where exactly does this go? I can't find anything anywhere to plug into and I haven't seen the fans turn on yet. Any help would be appreciated.
Thread Starter
Supreme Member
Joined: Oct 1999
Posts: 2,977
Likes: 1
From: Davison / Troy ,Michigan
Car: 1991 Pontiac Firebird
Engine: 3.8
Transmission: 700r4
Axle/Gears: Dana 60
Re: Electric Dual Fan Problems
Wow, did I mis-click the wrong forum. 
A mod mind moving this to General Tech?
A mod mind moving this to General Tech?
Thread
Thread Starter
Forum
Replies
Last Post
Dialed_In
Firebirds for Sale
2
Aug 20, 2015 01:45 PM
