bulkhead coil wire, real quick Q. (sry if wrong place)
Thread Starter
Joined: Feb 2005
Posts: 4,505
Likes: 90
From: West Warwick RI, postal code: 02893
Car: Building LS3, T56 Z28
Engine: LS3
Transmission: T-56
Axle/Gears: Moser/ 4.11
bulkhead coil wire, real quick Q. (sry if wrong place)
Sorry if this is the wrong board to post this question, but I have an ignition question and I feel like electronics is all stereo stuff.
I just mounted my new MSD Digital 6 box and HVC coil. I am trying to keep stuff out of the engine bay, so I mounted it on the inside of the car. It is well ventilated with plenty of air around it. What I want to do is get one of those coil bulkhead addapters for the interior mounted coil. That is the easy part. Where do I get the 2 wires that go from coil to bulk and bulk to dizzy?
Should I just get 2 "coil wire" sets and call it done or is there a better way? Thanks
-Dennis
I just mounted my new MSD Digital 6 box and HVC coil. I am trying to keep stuff out of the engine bay, so I mounted it on the inside of the car. It is well ventilated with plenty of air around it. What I want to do is get one of those coil bulkhead addapters for the interior mounted coil. That is the easy part. Where do I get the 2 wires that go from coil to bulk and bulk to dizzy?
Should I just get 2 "coil wire" sets and call it done or is there a better way? Thanks
-Dennis
Thread Starter
Joined: Feb 2005
Posts: 4,505
Likes: 90
From: West Warwick RI, postal code: 02893
Car: Building LS3, T56 Z28
Engine: LS3
Transmission: T-56
Axle/Gears: Moser/ 4.11
Re: bulkhead coil wire, real quick Q. (sry if wrong place)
Order placed yesterday, should get here tomorrow. Finally I will learn the joy that is CD ignitions, haha.
Thread
Thread Starter
Forum
Replies
Last Post
Pac J
Tech / General Engine
3
May 17, 2020 10:44 AM
