March Power Steering Pulley
Thread Starter
Senior Member
Joined: Jul 2001
Posts: 667
Likes: 2
From: Louisville Kentucky U.S.A.
Car: 86 Iroc Z
Engine: 406
Transmission: 350 Turbo
Axle/Gears: 373
March Power Steering Pulley
Has anyone put this type of after market bracket and pulley set on their third gen and if you have what problems did you run into?
I bought this set and the directions are very vague.
I bought this set and the directions are very vague.
Joined: May 2003
Posts: 712
Likes: 8
From: Elyria, Ohio
Car: 82 Z-28
Engine: Built 406ci
Transmission: 700R4 w/3000 stall
Axle/Gears: 3.73 Torsen Posi, Moser Axles
Re: March Power Steering Pulley
I have that same setup along with the pulley on my car with the v-belt and yes the directions are a little vague, but it does work good. The biggest challenge is the bolts that are behind the pulley somewhat. I had to thread them in by hand and getting them started was a bit of a challenge. If you have the pulley off then put the bracket on then maybe put the pulley on if you are changing out that pulley. Makes a nice setup.
Thread
Thread Starter
Forum
Replies
Last Post
colton_carlson
Firebirds for Sale
7
Mar 8, 2019 12:21 PM
evilstuie
Engine/Drivetrain/Suspension Wanted
15
Apr 14, 2016 08:52 PM
sailtexas186548
Problems / Help / Suggestions / Comments
2
Aug 24, 2015 10:11 PM
