tailshaft housing
Thread Starter
Member
iTrader: (1)
Joined: Oct 2006
Posts: 105
Likes: 0
From: cleveland, ohio
Car: 1986 camaro z28
Engine: vortec 5.7
Transmission: 700r4
Axle/Gears: 2.73
tailshaft housing
i have a 700r4 out of my 92 bird that is for a 3.1 , will that shaft housing work on a 700r4 out of a truck with a sbc (i swapped to a 350 in my 92 bird) if i were to get one to put in my car so that i have the torque arm mount? also i was wondering what kinda of cheap$ manual tranny would be good to put use if i were to convert my car, i heard that t5's aren't strong enough to handle more than 280 torque?
Joined: Mar 2000
Posts: 43,187
Likes: 45
From: Littleton, CO USA
Car: 82 Berlinetta/57 Bel Air
Engine: L92/LQ4 (both w/4" stroke)
Transmission: 4L80E/4L80E
Axle/Gears: 12B-3.73/9"-3.89
Sorry, missed your thread earlier.
The TH700R-4 tailshaft housings interchange between 60-degree V6 and 90-degree V6/V8 transmissions.
There is no good, cheap manual transmission. If you are converting, the best bet is to find an LT1 f-body ('93-'97 V8) T56 take-out.
The TH700R-4 tailshaft housings interchange between 60-degree V6 and 90-degree V6/V8 transmissions.
There is no good, cheap manual transmission. If you are converting, the best bet is to find an LT1 f-body ('93-'97 V8) T56 take-out.
