Code 43 and no start
Thread Starter
Junior Member
Joined: May 2008
Posts: 39
Likes: 0
From: Baltimore, MD
Car: 1990 Cadillac Fleetwood Brougham
Engine: Chevy 350 TBI with some goodies
Transmission: TH-7OO-R4, waiting for rebuild
Axle/Gears: Stock. Saving for 3.73 posi unit.
Code 43 and no start
I posted this one over on the "electrical board".
The situation is I got a code 43 and my vehicle will not start. It has spark going to the plugs. I replaced the ESC module and still no start. Fuel pressure is good. What else is incorporated with and ESC issue? Thank you for the help.
The situation is I got a code 43 and my vehicle will not start. It has spark going to the plugs. I replaced the ESC module and still no start. Fuel pressure is good. What else is incorporated with and ESC issue? Thank you for the help.
Thread Starter
Junior Member
Joined: May 2008
Posts: 39
Likes: 0
From: Baltimore, MD
Car: 1990 Cadillac Fleetwood Brougham
Engine: Chevy 350 TBI with some goodies
Transmission: TH-7OO-R4, waiting for rebuild
Axle/Gears: Stock. Saving for 3.73 posi unit.
Re: Code 43 and no start
Could leaving the car in the "run" position without starting it up cause this? I was scanning my car and did not actually start it up. It sat in the "run" position for a good 5-10 minutes. Did I possibly fry something?
Thread Starter
Junior Member
Joined: May 2008
Posts: 39
Likes: 0
From: Baltimore, MD
Car: 1990 Cadillac Fleetwood Brougham
Engine: Chevy 350 TBI with some goodies
Transmission: TH-7OO-R4, waiting for rebuild
Axle/Gears: Stock. Saving for 3.73 posi unit.
Re: Code 43 and no start
Anybody?? The fuel pressure is normal, getting spark, I did all the neccesary checks.
Thread
Thread Starter
Forum
Replies
Last Post
