Hey guys -

I have a car that had no engine in it, so I am building the engine myself. It's a carbed 383, and it's almost done.

I got the accessory setup for my engine (brackets, A/C compressor, alternator, etc...) from an '89 Camaro at a junkyard (looks like an IROC). The engine was a 305 TBI, I think.

Problem is that I don't have the water pump, and I don't have the serpentine pulley for the water pump. Based on the picture here (this is the car I got the acc. parts from), I have two questions:

• When I go to the junkyard for parts, what other make/models would have the correct water pump pulley for this serpentine setup?
• Water pump; standard rotation Chevy long neck, I assume?

Thanks in advance for your insight!

 

Can't help on the pulley, but it's serpy's use reverse rotation, long.

 

The following link may provide some helpful into:

https://www.thirdgen.org/forums/afte...rsion-kit.html

JamesC

 

any '88-mid 1990s SBC car or pickup will have the
right pulley