quick dumb question...
Thread Starter
Senior Member
Joined: Nov 2006
Posts: 504
Likes: 1
Car: 1985 Camaro and 1996 Mustang GT
Engine: 350 4bbl/281
Transmission: 700R4/4R70W
Axle/Gears: 9" rear/8.8" 4.10
quick dumb question...
what is the best way to get the rod caps off of freshly pressed rods?
forged i beam rods and ARP rod bolts.
thanks.
forged i beam rods and ARP rod bolts.
thanks.
Joined: Aug 2006
Posts: 12,812
Likes: 109
From: Central NJ
Car: 86 Trans Am
Engine: 408 stroker sbc
Transmission: TKO600
Axle/Gears: Moser full floater m9, 3:70 trutrac
Re: quick dumb question...
something like this
http://store.summitracing.com/partde...5&autoview=sku
http://store.summitracing.com/partde...5&autoview=sku
Thread Starter
Senior Member
Joined: Nov 2006
Posts: 504
Likes: 1
Car: 1985 Camaro and 1996 Mustang GT
Engine: 350 4bbl/281
Transmission: 700R4/4R70W
Axle/Gears: 9" rear/8.8" 4.10
Re: quick dumb question...
something like this
http://store.summitracing.com/partde...5&autoview=sku
http://store.summitracing.com/partde...5&autoview=sku
Thread Starter
Senior Member
Joined: Nov 2006
Posts: 504
Likes: 1
Car: 1985 Camaro and 1996 Mustang GT
Engine: 350 4bbl/281
Transmission: 700R4/4R70W
Axle/Gears: 9" rear/8.8" 4.10
Re: quick dumb question...
got it done the caveman way... i used 2 small pieces of wood a foot long and hammered in wood shims to seperate them. lol.
it wasnt bad and didnt cause any damage. everything is still in spec not to mention perfect for OOR on all of them.
it wasnt bad and didnt cause any damage. everything is still in spec not to mention perfect for OOR on all of them.
Thread
Thread Starter
Forum
Replies
Last Post
3.8TransAM
NW Indiana and South Chicago Suburb
1
Sep 27, 2015 08:37 PM