Easy Question, but don't know the answer
Thread Starter
Member
Joined: Nov 2008
Posts: 165
Likes: 0
From: The Wild West AKA AZ
Car: 87 Iroc Z
Engine: 350 TPI
Easy Question, but don't know the answer
Didn't know where to post this one, so I figure I would post it here.
On the foglight housing on the camaro, I was wondering what kind of screw held the foglight in place. I have one missing and wasn't quite sure if it required a special kind of screw/clip or whatever it may be. I looked in my book and even that didn't show what kind of screw it was.
Anyone have an answer to this? That, and what size it might be? All help is greatly appreciated, as I really don't like closing the hood just to have the foglight fall out.
On the foglight housing on the camaro, I was wondering what kind of screw held the foglight in place. I have one missing and wasn't quite sure if it required a special kind of screw/clip or whatever it may be. I looked in my book and even that didn't show what kind of screw it was.
Anyone have an answer to this? That, and what size it might be? All help is greatly appreciated, as I really don't like closing the hood just to have the foglight fall out.
Thread
Thread Starter
Forum
Replies
Last Post