Tech / General Engine Is your car making a strange sound or won't start? Thinking of adding power with a new combination? Need other technical information or engine specific advice? Don't see another board for your problem? Post it here!
Sponsored by:
Sponsored by: CARiD

1987 Camaro 2.8

Thread Tools
 
Search this Thread
 
Old Feb 4, 2010 | 08:41 AM
  #1  
that1guy's Avatar
Thread Starter
Junior Member
 
Joined: Feb 2010
Posts: 4
Likes: 0
From: Fruitland Park,Fl.
Car: 1987 Camaro Sport Coupe Berlinetta
Engine: 3.1
Transmission: Auto
1987 Camaro 2.8

Hello all, I am new to the site and have been trying to find my answers without having to post but no good.
I just bought a 1987 Camaro sport coup berlinetta for 500 off of a guy that couldnt have it in his yard any more and so far it has been worth every penny.
Here is what is going on, he replaced the motor that was in the car(the 2.8) with a 50,000 mile 3.1 but the wiring wouldnt match the 3.1 intake so he kept the 2.8 intake, he was getting 36MPG after he did it, about 5000 miles later it started to run rough so he paid a guy to do the plugs,wires,cap,rotor, the car ran the same if not worse, now it is mine and I have replaced the cap,rotor,wires,plugs,maf and still no change.
Where do I go from here? Any help would be great.
Reply
Old Feb 4, 2010 | 09:13 AM
  #2  
jensen73110's Avatar
Supreme Member
iTrader: (4)
 
Joined: Nov 2003
Posts: 1,049
Likes: 1
From: Oklahoma City
Car: 1991 Firebird
Engine: 3.1L +bolt ons
Transmission: 700R4
Axle/Gears: Moser forged, 3.73, SLP posi
Re: 1987 Camaro 2.8

Welcome.

Does it start fine?
Does it run rough immediately or when it warms up?
Any other issues like lack of power or overheating?
Check engine light?
Have you checked the timing?
Reply
Old Feb 4, 2010 | 09:16 AM
  #3  
that1guy's Avatar
Thread Starter
Junior Member
 
Joined: Feb 2010
Posts: 4
Likes: 0
From: Fruitland Park,Fl.
Car: 1987 Camaro Sport Coupe Berlinetta
Engine: 3.1
Transmission: Auto
Re: 1987 Camaro 2.8

It cranks for a few before it fires up but it runs rough from the start, the idle goes up and down untill it warms up then it just runs rough. I did not check the timing because I did not want to mess with that unless someone wiser in these cars told me to.
Reply
Old Feb 4, 2010 | 09:20 AM
  #4  
that1guy's Avatar
Thread Starter
Junior Member
 
Joined: Feb 2010
Posts: 4
Likes: 0
From: Fruitland Park,Fl.
Car: 1987 Camaro Sport Coupe Berlinetta
Engine: 3.1
Transmission: Auto
Re: 1987 Camaro 2.8

I forgot a few, yes the check engine light is on and it does feel like a loss of power unless you get on it a bit, if you just press the gas to go it will hesitate and stammer a bit.
Reply
Old Feb 4, 2010 | 09:46 AM
  #5  
that1guy's Avatar
Thread Starter
Junior Member
 
Joined: Feb 2010
Posts: 4
Likes: 0
From: Fruitland Park,Fl.
Car: 1987 Camaro Sport Coupe Berlinetta
Engine: 3.1
Transmission: Auto
Re: 1987 Camaro 2.8

I was just out messing with the car and my neighbor came over and said the reason it was running like it is is because of an exhaust leak in my pass. side manifold. Sound right? When I ran the codes for the check engine light it said MAF low power or something like that, I just replaced that part.
Reply
Old Feb 4, 2010 | 03:43 PM
  #6  
jensen73110's Avatar
Supreme Member
iTrader: (4)
 
Joined: Nov 2003
Posts: 1,049
Likes: 1
From: Oklahoma City
Car: 1991 Firebird
Engine: 3.1L +bolt ons
Transmission: 700R4
Axle/Gears: Moser forged, 3.73, SLP posi
Re: 1987 Camaro 2.8

Sensor sounds more plausible to me.
I believe an exhaust manifold leak would be loud and hot (ie, pretty obvious).
Reply
Old Apr 6, 2010 | 09:34 PM
  #7  
kait119's Avatar
Junior Member
 
Joined: Apr 2010
Posts: 2
Likes: 0
Re: 1987 Camaro 2.8

Hi i have the same car and my check engine light is on. i dont know what the problem could be. what should i look for
Reply
Related Topics
Thread
Thread Starter
Forum
Replies
Last Post
Cleotiz
Electronics
7
Jan 6, 2018 08:56 PM
E Rod
LTX and LSX
5
Aug 28, 2015 05:17 AM
beachrodder
Tech / General Engine
7
Aug 25, 2015 08:05 AM
drewdock87
South Central
3
Aug 18, 2015 09:02 PM
jahblah
Tech / General Engine
5
Aug 12, 2015 05:54 PM




All times are GMT -5. The time now is 06:08 PM.