So, I've been a member here for a while, I've read a lot over the years from this board, love it. I put a 305 from a TA into my '89 Toyota X-cab and I have very little room in front of it. The stock intake "boot" that hooks up to the MAF sensor is too long. It hits my rad and I can't close my hood.

See:








Now, correct me if I'm wrong, but, an LT1 boot has the same dimensions as the one I have at each end right? I'm looking at this one on Ebay. http://cgi.ebay.com/ebaymotors/Cast-...Q5fAccessories Do any of you guys have one of these installed? If you do, could you measure it for me and let me know how deep it is? I asked the seller but they haven't replied yet.

I like the nitrous bung, it'll make future upgrades easier!


Thanx guys!!

Jeff

 

TTT

Any help would be appreciated, thanks.