tbi on late model engine
Thread Starter
Junior Member
Joined: Aug 2010
Posts: 3
Likes: 0
tbi on late model engine
I have a pre 1986 block with early model heads off a corvette 1969. It is a 383 stroker hopefully pulling around 400-450 hp. I have a direct replacement L460 700R4 trans. It has a carb right now but I want to convert to a tbi. Putting it in a 1991 RS. Wondering if I should stick with an original wiring harness or go with a universal one. Have an original harness but not sure it is in good enough shape to use it after this much work. My car is a shell right now so a lot of effort to go with crappy wire. Plus electrical issues are NEVER fun when you have to hunt them down in the car. Anyone with computer knowledge would be a great help. Smart but not nerd smart so computers and electronics basics are all I am good for. Thanks in advance.
Thread
Thread Starter
Forum
Replies
Last Post
