how should it be balanced?
Thread Starter
Joined: Jul 2007
Posts: 358
Likes: 2
From: Waukesha, WI
Car: 86 Camaro Z28
Engine: LT1 200cc Ai heads and cam
Transmission: T56
Axle/Gears: 4.10:1 Zexel Torsen
how should it be balanced?
I picked up an LT1 to swap into my camaro. When I went to pull the hub off to replace gasket while it was out I found the threads from the crank on the bolt. I already have the new cast crank and aluminum fly wheel. I'm reusing the origional hub and balancer. How should I have the hub and flywheel balanced?
Thread
Thread Starter
Forum
Replies
Last Post
monte87cortez
Transmissions and Drivetrain
2
Sep 26, 2015 08:10 PM
roysatikas
Transmissions and Drivetrain
0
Sep 22, 2015 08:15 PM