Is the PCV valve suppose to pull out super easy, or is it wrong size???
Thread Starter
Member
Joined: Feb 2011
Posts: 139
Likes: 0
Car: 1989 Iroc-Z 350
Is the PCV valve suppose to pull out super easy, or is it wrong size???
Been having some idle problems but not too bad. So that hose that goes from the intake manifold to my right head into the PCV valve. Barely tugged on it and the PCV valve just pulls right out of the head very easily. Is that normal?
Last edited by nakota2k; Apr 14, 2011 at 04:56 PM.
Member
Joined: Apr 2008
Posts: 360
Likes: 0
From: Minnesnowta
Car: 1987 Camaro Z28
Engine: 355ci, XE262 , 650dp
Transmission: T-5, RAM clutch
Axle/Gears: 3.23 limited slip
Re: Is the PCV valve suppose to pull out super easy, or is it wrong size???
shouldnt be a problem. you could replace the gromet if it eases your mind
Joined: Sep 2005
Posts: 27,893
Likes: 2,436
Car: Yes
Engine: Usually
Transmission: Sometimes
Axle/Gears: Behind me somewhere
Re: Is the PCV valve suppose to pull out super easy, or is it wrong size???
Yup; kinds depends onyour definition of "super easy". It shouldn't fall out if you pick up the motor and turn it upside down, but it shouldn't resist a pull either.
Thread
Thread Starter
Forum
Replies
Last Post
1992 Trans Am
History / Originality
27
May 10, 2023 07:19 PM
toronto formula
Engine/Drivetrain/Suspension Parts for Sale
15
Nov 10, 2015 06:17 AM
knight72
Engine/Drivetrain/Suspension Wanted
0
Aug 10, 2015 09:32 PM
