Installing gauges
10-14-2011, 08:39 PM
#1
Junior Member
Thread Starter
Join Date: Aug 2011
Location: Atlanta, Ga
Posts: 68
Likes: 0
Received 0 Likes
on
0 Posts
Car: 82 Firebird/ 79 Camaro Berlinetta
Engine: 151 Pontiac Iron Duke TBI/ 305 SBC
Transmission: THM200/ THM200r4
Axle/Gears: 2.93/ 2.41
Installing gauges
Okay here is the deal, ive been working on changing my head gasket on my firebird, well i planned installing a gauge pod cause my car lacks actual water and oil pressure gauges while im under the hood.
Ive ran into a the problem were to feed the copper coil and plastic tubing from my gauges to my block, do i need to drill a hole in the firewall or is there a factory made opening i cant slip them through any tips or advice would be some help. Thank you
Ive ran into a the problem were to feed the copper coil and plastic tubing from my gauges to my block, do i need to drill a hole in the firewall or is there a factory made opening i cant slip them through any tips or advice would be some help. Thank you
10-15-2011, 10:06 AM
#2
Member
iTrader: (3)
Join Date: May 2004
Location: NY
Posts: 264
Likes: 0
Received 2 Likes
on
2 Posts
Car: Currently Looking
Engine: Five Seven
Transmission: 700R4
Axle/Gears: 3.27
Re: Installing gauges
If you look under your dashboard and pull off the trim, you should be able to see your firewall. There should be holes in it with grommets to allow wiring to go from the passenger area to the engine bay. You could proudly just use the existing holes to slip the wiring through
Thread
Thread Starter
Forum
Replies
Last Post
86IROC112
Engine/Drivetrain/Suspension Parts for Sale
4
08-17-2015 02:00 PM