I'm not sure how to hook up my new mini starter?
Thread Starter
Moderator
Joined: Jul 2001
Posts: 5,225
Likes: 70
From: Buffalo, NY
Car: 1988 IROC-Z
Engine: 427 SBC
Transmission: ProBuilt 700R4
Axle/Gears: Moser 12 Bolt / 3.73 TrueTrac
I'm not sure how to hook up my new mini starter?
My stock starter has a large stud with a nut on the end. All my wires for my starter go to this except a little purple one. Then there is a skinny stud with a nut on the end the purple wire goes to.
My new starter has two large studs/nuts. And another yellow slip fit connection. Does anyone know how I should hook it up? Here's a picture of the new starter:
Thanks guys.
My new starter has two large studs/nuts. And another yellow slip fit connection. Does anyone know how I should hook it up? Here's a picture of the new starter:
Thanks guys.
Last edited by IROCThe5.7L; Feb 4, 2013 at 12:07 AM.
Joined: Apr 2005
Posts: 7,736
Likes: 14
From: Not in Kansas anymore
Car: 82 Z28
Engine: 383 SP EFI/ 4150 TB
Transmission: T400
Axle/Gears: QP 9" 3.73
Re: I'm not sure how to hook up my new mini starter?
All the wires go on the top stud of solenoid and the purple gos to the small terminal with the yellow connector
You only have to look at it
As shown in your pic , the bottom stud on the solenoid has a brass link that puts power from the solenoid
to the starter motor
As shown in your pic , the bottom stud on the solenoid has a brass link that puts power from the solenoid
to the starter motor
Thread Starter
Moderator
Joined: Jul 2001
Posts: 5,225
Likes: 70
From: Buffalo, NY
Car: 1988 IROC-Z
Engine: 427 SBC
Transmission: ProBuilt 700R4
Axle/Gears: Moser 12 Bolt / 3.73 TrueTrac
Re: I'm not sure how to hook up my new mini starter?
Good stuff. Thanks for the quick reply! 
Thread
Thread Starter
Forum
Replies
Last Post
