Ignition lock cylinder replacement question.
Thread Starter
Member
Joined: Oct 2011
Posts: 344
Likes: 2
From: Paris Texas
Car: 91 Camaro RS, 84 2.8 5speed
Engine: 305 5.0L
Transmission: Auto, 5 speed
Ignition lock cylinder replacement question.
Alright, my key wont turn to acc or anything, im replacing the lock cylinder, but i ran into a problem. How do I get the plastic circular thing off? its right there as soon as the steering wheel is of, i can turn it woth a tap of a screwdriver, but i'm not going to try anymore I dont want to break anything.
So what are the steps after the steering wheel removal to get to the lock cylinder???
So what are the steps after the steering wheel removal to get to the lock cylinder???
Thread Starter
Member
Joined: Oct 2011
Posts: 344
Likes: 2
From: Paris Texas
Car: 91 Camaro RS, 84 2.8 5speed
Engine: 305 5.0L
Transmission: Auto, 5 speed
Re: Ignition lock cylinder replacement question.
Ok guys, nevermind, my friend found a great vid on how to do this lol. Heres a link for anyone needing to replace their ignition lock cylinder in a very informal step-by-step video:
Joined: Sep 2000
Posts: 2,504
Likes: 195
From: Moorpark, CA
Car: '91 GTA, '92 T/A Convertible
Engine: GTA: 350 w/Vortec heads, T/A: 305
Transmission: Pro-built 700R4
Axle/Gears: GTA: 3.27, T/A: 2.73
Re: Ignition lock cylinder replacement question.
Shoot me a PM if you get stuck. I just replaced my ignition cylinder a few months ago.
Thread Starter
Member
Joined: Oct 2011
Posts: 344
Likes: 2
From: Paris Texas
Car: 91 Camaro RS, 84 2.8 5speed
Engine: 305 5.0L
Transmission: Auto, 5 speed
Re: Ignition lock cylinder replacement question.
I got it out and in without a problem 
even fixed my signal switch while I was in there
even fixed my signal switch while I was in there 
Thread
Thread Starter
Forum
Replies
Last Post
1992 Trans Am
History / Originality
27
May 10, 2023 07:19 PM
Zachattack0925
Tech / General Engine
2
Aug 12, 2015 09:54 PM
Zachattack0925
Transmissions and Drivetrain
4
Aug 12, 2015 09:52 PM
