Welding Subframe
Thread Starter
Junior Member
Joined: Feb 2008
Posts: 3
Likes: 0
Car: 92 RS 25th
Engine: 5.0
Transmission: T5 5 speed manual
Axle/Gears: 3.73
Welding Subframe
I've worked on Firetrucks for about 12 years, and whenever we needed to weld on the chassis, we would always disconnect the ECM for the engine. My subframe on my 92 Camaro is cracked around the steering gear mount. I was going to reinforce it by welding plates on both sides of the subframe. Should I disconnect the ECM? Will it result in a "Reset" of the motor function?/possibly make it run bad? Just wanted to be safe then sorry.
Thanks Also............is there anyway to reset the Tac on the dash?
Thanks Also............is there anyway to reset the Tac on the dash?
Thread
Thread Starter
Forum
Replies
Last Post
no green
Engine/Drivetrain/Suspension Parts for Sale
11
Jan 9, 2016 09:22 PM
tmork454
Transmissions and Drivetrain
0
Sep 29, 2015 06:33 PM
