Pull Motor & Leave 5 Speed in Car?
Thread Starter
Junior Member
Joined: Aug 2011
Posts: 14
Likes: 0
Pull Motor & Leave 5 Speed in Car?
I'm pulling my 350 out of my Iroc and replacing it with a built 355. The car is a 5 speed and I want to just unbolt the bell housing and yank the motor then replace it bolting the bell housing right back up to it. I've done a lot of automatics this way but not a manual trans, has anyone done a manual trans this way?
Joined: Sep 2005
Posts: 27,918
Likes: 2,448
Car: Yes
Engine: Usually
Transmission: Sometimes
Axle/Gears: Behind me somewhere
Re: Pull Motor & Leave 5 Speed in Car?
Yup. I prefer it in fact. Gotta be pretty careful with the pilot while stabbing it back in; other than that, IMO it's the eeeeeeziest way.
Thread
Thread Starter
Forum
Replies
Last Post
Ghettobird52
Tech / General Engine
16
Jul 5, 2024 11:18 PM
