Hey guys. I just installed a new ecm because my old one was defective. The weird running issues seem to be over, but now I have a code 36. The car has a new mass air sensor and new-er mass air relay. Since I bought the car a couple months ago, the car has always started up fine, ran for 2-3 seconds then stalled, when cold. Once I turn the key again, it will start and stay running. It seems like a mass air problem, but as I mentioned, the meter and relay have been replaced.. Through some searching, I found the thread about the differences in mass air burnoff relays, some have a resistor and some don't... Could this be the problem?? Thanks