Vortex TPI Manifold
Thread Starter
Senior Member
iTrader: (1)
Joined: Sep 2015
Posts: 683
Likes: 19
From: Knoxville, TN
Car: 1988 IROC-Z
Engine: 350 TPI
Transmission: T56 swap ongoing
Axle/Gears: 2.77 9-bolt Posi
Vortex TPI Manifold
Still seriously considering Vortec Heads on my '88 L98, and retain the TPI setup . Since the manifolds have been discontinued, it would seem to make the most sense to start there. I've found an Edelbrock 3817 manifold. Is this the correct manifold for my Camaro?
Joined: Jul 2000
Posts: 6,519
Likes: 91
From: Aridzona
Car: `86 SS / `87 SS
Engine: L69 w/ TPI on top / 305 4bbl
Transmission: `95 T56 \ `88 200-4R
Re: Vortex TPI Manifold
There's an external EGR feed.
https://www.thirdgen.org/forums/tpi/...ortec-tpi.html
I don't know if you can utilize the heat riser passages in stock L98 heads for EGR.
https://www.thirdgen.org/forums/tpi/...ortec-tpi.html
I don't know if you can utilize the heat riser passages in stock L98 heads for EGR.
Thread
Thread Starter
Forum
Replies
Last Post